JUNIOR DIVISION

FALL SCHEDULE

Sept 14, 21, 28
Oct 5 & 19
Nov 2, 9, 16 

COST: $5.00 per race
NOTE:  No race on Oct.12 or Oct. 26

Will race on Sunday afternoons at 5 p.m. on black track beginning Sept. 14

BODY 
1.   Body must be painted with clear windows where applicable.
2.   Maximum rear height of 1 5/8".
3.   Juniors may use "Wedge" or "Ultimate" style high downforce bodies until having scored 3 wins. After
wins must run alow downforce body.

CHASSIS 
1.   Must be a commercially available approved chassis.
2.   Must be stamped and formed metal. The portions to which the motor is attached must be steel.
3.   May interchange parts from a single manufacturer, such as Flexi and Flexi 2 parts, JK long or short   center sections and heavy or light pans on JK chassis.
4.   Chassis may have a maximum of three (3) chassis parts consisting of one solid center section and maximum of two separate pans. No additional pans or two piece center sections allowed.
 5.  No modifications except for the following:
        a. May solder or glue motor, axle oilites and front wheel retainers.
        b. May add lead weight and tape to chassis.
        c. May file holes in motor bracket to allow better gear mesh, but must retain a portion of
motor bracket.
        d. No oilite modifications allowed. MMay use offset oilites.
        e. May add a one inch (25.4 mm) long motor brace and an upright brace.
        f. The original manufacturer's plating may be removed only in areas to be soldered.
        g. May add pin tubes. Pin tubes may be either solid or floating. May add lead wire retainer.
        h. May solder on steel guide tongue reinforcement such as Slick 7 but the original  tongue
can not be modified or moved.
        i. No other modifications, soldering, cutting, grinding or bracing allowed.
        j. May use any guide, nut, spacers, lead wire and clips.
        k. May perform reasonable filing or rear oilite chassis holes to allow for axle alignment.
        l.  Car that starts race will be the one to finish. No switching cars.
     
MOTOR AND GEARS 
1.   Motor must be a sealed Parma 501 "Death Star" motor.
2    If motor brace is used there must be a minimum of .060th clearance under screw end to track surface.
4.   Any gear ratio is allowed, 48 pitch gears.

RACE DIRECTOR
1.   Cars impounded after tech.
2.   Sit out will have 1 1/2 min. to set car on track and get ready.
3.   When exiting the white lane mark lane and return car to impound box.
4.   Sit outs will marshall, no exceptions.
5.    Anyone gluing tires will be disqualified and banned for 2 races.